Your water heater is one pretty used and higher priced appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and costs.

Regular flushing of your water heater is considered the single most important step you can take to prolong its service life and to save energy. In a period of time, sediments enhance in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most associated with the country, the standard water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a month.

To drain your water heater, which will help should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located on the water inlet line going into your water heater. You can then connect a hose to the drain valve located towards the bottom of the heater. Open the drain and allow it to function until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until the actual flows out perfectly. This will allow air to vent from the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to suit your needs.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2